This is the parts list for the one day program "Introduction to electricity and electronics" in the "Robotics: Learn by building" series.  Tools that are needed for the program will be provided.

Electronics parts:
breadboard
breadboard jumper wire kit, or make a bunch of your own jumper wires
resistors - just get a variety pack
capacitors - just get a variety pack of large (1uf - 100uf) and small (10pf to 0.1 uf)
Variable resistors (potentiometers): one 10k and one much larger, 500k to 1 meg range
	-these need to have solid wires soldered to them so we can use them in a breadboard
LED's - a variety of them, with wires. Don't get the surface mount ones.
1 germanium diode
1 silicone diodes
6 volt relay with SPDT switch (the voltage will depend on your choice of battery or battery pack - either 6 volt or 9 volt)
	-most likely you will need wires soldered to your relay to be able to use it in a 	readboard
momentary pushbutton
push-on/push-off pushbutton or switch (optional)
1 IRFZ44N MOSFET power transistor, or some equivalent power transistor
2 X 2N2222 transistors
2 X 2N2907 transistors
2 X NE555 timers (or equivelent - any 555 timer chips will do)
a speaker
small DC motor - NOT a brushless motor!
hobby servo motor of any size
two battery packs with 6 volts or more. This can be:
	-9 volt battery clips with wires
	-4 X AA battery holder 
	-lantern batteries
CDS photocell (cadmium sulfide cell)
alligator clips (at least two)
thermister

If you have any questions, feel free to email or call the program instructor: ianjuby@ianjuby.org or 613-281-5585